Armstrong 3031 설치 및 유지 관리 매뉴얼 - 페이지 14

{카테고리_이름} Armstrong 3031에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Armstrong 3031 20 페이지. Water temperature controls groups of fixtures - thermostatic

페이지 인쇄

Servicing & Maintenance

Warning! Isolate water supply to Model 320 before proceeding.

Model 320 Thermostatic Mixing Valves and its components should be inspected annually, or more frequently where

acknowledged site conditions such as high mineral content water dictate.

Model 320 Thermostatic Mixing Valve is of a sealed single "cartridge construction". The cartridge can be removed

from the valve for inspection or replacement. To access the valves internal components for inspection, cleaning or

replacement proceed as follows.

Maintenance must be carried out in accordance with these instructions, and must be conducted by designated,

qualified and competent personnel. This mixing valve is designed for minimal maintenance under conditions of

normal use. External surfaces may be wiped clean with a soft cloth, and if necessary, a mild detergent or soap

solution can be used.

Warning! Many household and industrial cleaning products contain mild abrasives and chemical concentrates,

and should not be used on polished, chromed or plastic surfaces.

Components are precision-made, so care must be taken while servicing to avoid damage.

Lubricant

Important! All seals are pre-lubricated. If you need to further lubricate the seals, use only a small amount of

silicone-only based lubricants on this product. Do not use oil-based or other lubricant types as these may cause

rapid deterioration of seals.

Maintenance Procedure - Cartridge Assembly

Isolate the water supplies to the mixing valve. Open an outlet fitting to release pressure and to assist the draining

of residual water.

Step 1

3 mm