DIS Audio Output Unit AO 6004 사용자 설명서 - 페이지 12
{카테고리_이름} DIS Audio Output Unit AO 6004에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIS Audio Output Unit AO 6004 14 페이지. Audio output unit for dcs 6000
페이지 인쇄Danish Interpretation Systems
Appendix
Technical appendix
Cabling
CAT5
The DCS 6000 system uses CAT5, CAT5e or
CAT6 FTP or STP cables with screened RJ45
connectors.
EIA 568-B wiring shall be used.
It is important to use only FTP or STP
(screened) cables and screened RJ45 connectors
and not UTP cable, which is unscreened.
How to wire a CAT5 (EIA 568-B) Cable:
Pin Function
Connector #1 Connector #2
1
In-going +
ORG/WHT
2
In-going -
ORG
3
+48V
GRN/WHT
4
0V
BLU
5
0V
BLU/WHT
6
+48V
GRN
7
Outgoing -
BRN/WHT
8
Outgoing +
BRN
Note.
If other colour codes are used then the four
pairs are connected as follows:
Pair 1:
Pin 1 & 2
Pair 2:
Pin 3 & 6
Pair 3:
Pin 4 & 5
Pair 4:
Pin 7 & 8
12
The phase of the pairs must be correct and the
wiring spec. as stated in CAT5 (EIA 568-B) have to
be followed.
Note: CAT6 cables can normally only be
terminated in sockets (female) and not in cable
plugs. CAT6 should thus only be used for long
cable draws terminating in wall outlets or patch
panels.
Analogue out (XLR3 male)
ORG/WHT
ORG
Accessories (not supplied)
GRN/WHT
BLU
EC 6000-..5 Connection Cable 0.5 m......................10 03 12500
BLU/WHT
EC 6000-01 Connection Cable 1 m.........................10 03 13101
GRN
EC 6000-02 Connection Cable 2 m.........................10 03 13201
BRN/WHT
BRN
EC 6000-05 Connection Cable 5 m.........................10 03 13501
EC 6000-10 Connection Cable 10 m.......................10 03 14102
EC 6000-20 Connection Cable 20 m.......................10 03 14202
EC 6000-50 Connection Cable 50 m.......................10 03 14502
Manual 01 18 04442
Pin
Signal
1
Ground
2
In phase signal
3
Out phase signal
User Manual
Cable type
DIS type #2914
2
or 2 x 0,25 mm
shielded.