DIS Sensors QG40N 사용자 및 안전 매뉴얼 - 페이지 5

{카테고리_이름} DIS Sensors QG40N에 대한 사용자 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIS Sensors QG40N 6 페이지. Tilt/acceleration switch (sil1 plc)
DIS Sensors QG40N에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지), 사용자 설명서 (15 페이지)

페이지 인쇄

QG40N Tilt SIL1 PLc

User Safety Manual v1.3

page 5 of 6

10.4

Delay times

Each switching output is preprogrammed to have certain on/off delays. See datasheet for details

These delays can be tuned by the customer in case of the tilt switch (optional QG40N configurator)

11 Internal diagnostic tests

To ensure safety the hard- and software of the safety sensor is continue checked to a certain extend (Diagnostic Coverage) .

When a failure is detected both outputs will switch to non-conducting. Non-conducting should lead to 'low' thanks to

external pull down resistor. Customer shall consider this situation as 'unsafe' and take appropriate actions to bring the

application to 'safe-state'

12 Document revision control

v0.1 Draft by MvA

v1.0 After review by RM

v1.1 Chapter 4: PLd corrected to PLc

v1.2 20200225 Available measuring ranges updated

v1.3 20200525 Acceleration switch functions added