ABBA SPS02 설치 매뉴얼 - 페이지 3

{카테고리_이름} ABBA SPS02에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABBA SPS02 4 페이지. 12v landscape light specialist

페이지 인쇄

fixture(s) must be installed in accordance with all local codes and ordinances.

Do not instal within 10 feet of a pool, spa or fountain

INSTALLATION INSTRUCTION

To ensure optimal performance and safety, it

is important to use our fixtures ONLY with a

low

voltage

landscape

transformer reduces the voltage from 120V to

12V, making it safe and suitable for outdoor

use.

When installing the fixture(s), please follow

these instructions carefully:

1. Please ensure the light cable wires input are

12v ac/dc.

2. To establish a dependable and enduring

electrical connection between fixture wires

and the main line in outdoor or underground

installations, it is essential to select a suitable

main cable connector designed for direct

burial. This connector should be chosen based

on its ability to withstand environmental

conditions, resist moisture and corrosion, and

provide robust insulation. By adhering to

industry

standards

including proper wire stripping and secure

fastening techniques, a reliable connection

can

established,

performance, safety, and longevity of the

system.

We recommend using WN12 waterproof wire

nuts

(sold

separately)

connectivity.

3. Strip the insulation: Carefully strip

approximately 3/4 inch (1.9 cm) of insulation

from the ends of the two wires you wish to

connect. Ensure that the bare metal ends are

clean and free from any frayed strands.

4. Align the wires: Hold the stripped ends of

the two wires together, aligning them neatly

and ensuring that no stray strands are

crossing over.

CAUTION:

transformer.

This

and

best

practices,

ensuring

optimal

for

optimal

www.ABBALightingUSA.com

5.Insert the aligned ends of the wires into the wire

nut, ensuring that they go all the way in. The bare

ends should be completely covered by the wire

nut. Twist the wire nut: Firmly twist the wire nut

clockwise onto the wires, ensuring a secure

connection. Continue twisting until the wire nut is

tight and snug. Test the connection: Gently tug on

each wire to ensure they are securely held by the

wire nut.

The connection should be firm and not come loose.

Inspect the connection: Examine the wire nut

connection to ensure there are no exposed wires or

loose strands. If any issues are detected, remove

the wire nut and repeat the process from step 3.

Note: It's always recommended to follow local

electrical codes and regulations when performing

any

electrical

work.

uncomfortable with electrical tasks, it's advisable

to consult a qualified electrician. Safety should

always be a top priority when working with

electrical connections.

6. Remove the lens from the fixture.

7. Insert the bulb with the correct wattage.

8. Place the lens back onto the fixture.

9. For a secure and stable mounting, dig a small

hole and insert the spike into the ground, ensuring

it is vertical and firm.

10. Adjust the light angle.

11. Turn on the power.

We strongly recommend that the main cable from

the transformer be buried underground for safety

reasons. Additionally, please be sure to avoid

exceeding the maximum wattage on the fixture(s) to

prevent any damage or hazards.

you're

uncertain