Cub Cadet Domestic Series 7000 서비스 매뉴얼 - 페이지 7
{카테고리_이름} Cub Cadet Domestic Series 7000에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet Domestic Series 7000 13 페이지. Compact tractor
Cub Cadet Domestic Series 7000에 대해서도 마찬가지입니다: 서비스 매뉴얼 (4 페이지)
페이지 인쇄
3.8.
Remove the spring pin that holds the shift pin
assembly to the shaft that enters the transmis-
sion using a flat-nosed drift and a heavy ham-
mer.
spring pin
identified in
Figure 3.4
Figure 3.8
NOTE: It may be neccessary to bend the spring
pin in order to clear the spacer on the upper
mounting bolt for the hydro pump. The top end of
the spring pin is accessible through an opening
in the side of the frame.
3.9.
Disconnect the lift feedback rod from the hydrau-
lic lift control linkage using a 7/16" wrench.
3.10. Remove the two bolts that hold the control han-
dle bracket to the valve bracket assembly using
a 1/2" wrench and a 1/2" socket.
See Figure 3.10.
control handle
bracket
bolts
feedback
rod
Figure 3.10
3.11. Remove the grip from the end of the hydraulic
control handle.
See Figure 3.8.
NOTE: the shift pin
assembly is visible
through an opening
in the side of the
frame.
shift pin
assembly
shifter link assembly
flare fittings
hydraulic lift
control linkage
3.12. Remove the control handle and control handle
bracket from the tractor.
3.13. Remove the shifter link assembly from the han-
dle bracket using a 3/4" wrench.
3.14. Place a catch pan under the hydraulic lift control
valve.
3.15. Disconnect the two steel hydraulic lines from the
two elbow flare fittings on top of the valve using
an 11/16" wrench.
NOTE: Clean the area surrounding the hydraulic
fittings before disconnecting them. It is very
important not to contaminate the hydraulic sys-
tem.
NOTE: A crow-foot wrench may ease the job of
disconnecting the flare fittings, but is not abso-
lutely essential.
3.16. Remove the three bolts holding the valve mount-
ing bracket to the frame of the tractor using a 1/
2" wrench.
3.17. Remove the three bolts holding the valve to the
valve mounting bracket using a 7/16" wrench.
See Figure 3.17.
hydraulic control valve
valve mounting bracket
3
7000 High / Low Shift Kit
bolts
Figure 3.17