Armstrong Air BCS3M 24 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Armstrong Air BCS3M 24에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Armstrong Air BCS3M 24 18 페이지. Bce3m series; bcs3m series

Suspending Horizontal Unit

NOTE: When the unit is installed in horizontal applications,

a secondary drain pan is recommended. Refer to local

codes.

NOTE: This unit may be installed in left-hand or right-hand

air discharge horizontal applications. Adequate support

must be provided to ensure cabinet integrity. Ensure that

there is adequate room to remove service and access panels

if installing in the horizontal position.

Left-Hand Discharge

1. Determine knockouts required for drain line connections.

2. With access door removed, knock out drain line opening

for installing drain lines.

3. Set unit so that it is sloped toward the drain pan end of

the unit (see Figure 10).

4. The horizontal configuration is shown in Figure 3.

Left-Hand Discharge Configuration

5. If the unit is suspended, the entire length of the cabinet

must be supported. If you use a chain or strap, use a

piece of angle iron or sheet metal attached to the unit

(either above or below) to suppor the length of the

cabinet. Use securing screws no longer than 1/2 inch

to avoid damaging the coil or filter. See Figure 2. Use

sheet metal screws to connect the return and supply

air plenums as required

507120-01

Figure 2

Figure 3

Right-Hand Air Discharge

For horizontal right-hand air discharge, the following field

modifications are require.

1. Remove and set aside blower and coil access covers.

2. Remove brachet(s) securing pan(s) to unit as illustrated

in Figures 4 and 5.

Remove Main Drain Pan Mounting Bracket

Remove both Horizontal & Main Drain Pan Brackets

Issue 1324

(-018 through -036)

Figure 4

Figure 5

Page 5 of 18