Disc Makers ReflexFlash11 사용자 설명서 - 페이지 9

{카테고리_이름} Disc Makers ReflexFlash11에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers ReflexFlash11 13 페이지. High-speed usb duplicator

3. Button Beep (Menu Function 6.3)

This option will allow the user to turn on or off the audio signal when a button is pressed.

Press the UP and DOWN buttons to switch between ON and OFF. Press ENT to

select and exit.

[Button Beep]

4. Asyn Hold time (Menu Function 6.4)

This option allows the user to set the time the system waits when all writer trays are

unloaded before exiting the asynchronous mode. The default is set to 30 seconds.

When the system is in asynchronous mode, it executes the copy or compare function for

each writer tray individually. After all target drives are removed, the system will wait

for the set amount of time for any new drive to be inserted to continue the job. If no

more drives are inserted after the hold time, the LCD will prompt:

Wait too long

Press ENT to exit this Asynchronous or press ESC to keep this status.

5. Ignore Size (Menu Function 6.5)

This function is to set the tolerance in percentage of capacity difference between

source and target cards / drives. To ensure the FAT table of each drive is duplicated

correctly, the duplicator will require the source and all target cards/ drive to be identical

in capacity. However, it is inevitable for each drive, although marked the same capacity,

to be slightly different due to the manufacturing process. Therefore, a tolerance may

be set to avoid a system error. For example, if the source drive has a capacity of 1919MB,

with a 3% tolerance setting any target drive with a capacity of 1976MB to1861MB will be

accepted. Setting to a higher tolerance percentage will allow source flash copy to targets

with different capacity's, such as copying a 1GB source device to 2GB target device(s).

The default is set to "Don't care," which means the size difference is ignored and there is

no limit of source and target capacity difference.

If a source device has a smaller capacity than target devices:

1. Set the tolerance % to "Don't care". There will be no limit on source and target

capacity difference.

2. After the copy process is completed, the target devices will be formatted to the same

capacity as source device.

User Guide 1.0

ReflexFlash

Exit?