Disc Makers ReflexMax4 사용자 설명서 - 페이지 7

{카테고리_이름} Disc Makers ReflexMax4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers ReflexMax4 13 페이지. Cd reflexmax series
Disc Makers ReflexMax4에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

1. Copy the master to the hard drive by using the Image function. Press the

Down arrow until you see 9. Image then press the ENT button. You should

see the following displayed on the LCD screen:

9-01. Image

Load

2. Load the top drive with the master disc and press the ENT button. The mas-

ter disc will be copied to the hard drive and the display will read Image Load

3. Press the ESC key two times until 9. Image appears on the LCD display. Then

use the Up arrow to return to 1. Copy.

4. Load the drives with high-quality optical media and press the ENT button.

The duplication process will begin, and when completed, the ReflexMax will

eject the successfully copied discs. When the copy is complete the LCD will

read:

1. Copy

OK: 04

Appearing next to OK will be the number of successfully copied discs. In the

this example, 4 discs were successfully copied.

-D

ISC

OPYING

The ReflexMax is factory preset to do Hard-Drive-to-Disc copying. The unit can

be changed to Disc-to-Disc mode relatively easily.

1. From the 1. Copy screen, press the Down arrow until 8. Select Source

appears in the LCD screen.

1-888-800-4041

P:A

www.discmakers.com

2. Press the ENT button and the following display will appear:

SRC: hard drive

00 IDE0 Master

3. Press the Down arrow once for Src: CD-RW Ø1 IDE1 Master press the ENT

key and the new source will be the top CD recorder drive. The LCD will display

CD-RW selected!

4. Press the Up arrow to return to 1. Copy, notice that P: A is no longer dis-

played on the screen. This is how you can determine if your unit is operating

in the Disc-to-Disc copy mode or the Hard-Drive-to-Disc mode. The Hard-

Drive-to-Disc mode will always show the P:.. at the right side of the screen

and what partition of the drive is being used.

5. To begin the duplication operation, load the top drive the Src drive with the

master disc. Load the other recorders—one or as many as needed—with

high-quality CD-R media.

6. Press the ENT button to begin duplicating. The unit will automatically ana-

lyze the master disc (this may take several moments), and begin duplicat-

ing at the maximum recording speed.

9. The LCD will show the progress and display OK when the duplication is com-

plete. Upon successful duplication, all copied discs will be ejected. If any disc

fails the duplication, it will remain in the bottom drive.

The LCD will display:

1. Copy

OK: 03

In this example three discs were successfully copied.

The same duplication job may be continued by reloading the recorder drives