Disc Makers 1.1 사용자 설명서 - 페이지 12

{카테고리_이름} Disc Makers 1.1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers 1.1 15 페이지. Dvd disc duplicator

페이지 인쇄

3. Press the up or down arrow to change the track in view. To select a track to

copy to the blank disc press the ENT key, a + will appear next to the track in

view. In the following example track 3 is in view and is selected for copying.

Select Track:

+3/31

TRACK IN VIEW

TOTAL TRACKS ON DISC

More than one track can be chosen from a CD but they will be recorded to

the destination in the order in which they are on the original CD. To change

the order of play copy each track individually.

4. After selecting a track (or tracks) to copy press the up arrow until "End"

appears. In this example one track is selected and the time for this track is

2:41.

Select Track:

End

If four tracks were selected the screen would show "4 Trk" and give the total

time for all four tracks.

5. Load the other recorders, one or as many as needed, with high quality CD-R

media.

6. Press the ENT button and the ReflexPro DVDwill ask if all the selections are

made for this CD. Use the up or down arrow to change between Yes and No.

Pressing ENT with No on the LCD will take the user back to Select Track.

Pressing ENT with Yes on the screen will start the copying of the track (or

tracks) to the target CD.

End edit disc

and burn?

1-800-237-6666

3:18

TIME OF TRACK

1 Trk 2:41

YES

www.discmakers.com

7. When the copying ends the unit will display "Burn Complete! OK: 01". Press

the ENT button. The LCD will display "Continue edit next Disc? NO". To change

to another CD, Load the top recorder drive (Src) with another master disc,

press the up arrow to change the "No" to "Yes"and press ENT. This will take

you to the screen from step 3. Repeat steps 3 through 6 to add more tracks

on the compilation.

8. When there are no more tracks to write to the compilation leave the

"Continue edit next Disc? NO" set to "No" and press the ENT key again. The

following screen will appear:

Close all discs

session?

Press ENT and the ReflexPro DVD will close the CD.

The LCD will display "Close Complete OK: ... Fail: ..." the number of discs

closed successfully will be next to OK and they will be ejected, any failures

will remain in the recorder drives.

The ReflexPro DVD can compile to the hard drive as well, in step 2 use the

down arrow to to select "10-02. Edit Track DVD to hard drive Edit" and press

enter. Steps 3 and 4 will be the same to select the tracks to copy. It is not

necessary to load any media. Step 6 will load the selected track(s) to the

hard drive. The last few steps will be as follows:

7. When the copying ends the unit will display "Image load OK", pressing 'ENT

will display "Continue edit next Disc? NO" Leaving this set to "No" and press-

ing 'ENT' the screen will display "Burn or Move to partition? Burn". Use the

down arrow to change the "Burn" to "Move" then press 'ENT'. "Select Partition

A" will be displayed. Use the down arrow to select a partition to copy to and

YES