Disc Makers Reflex1 사용자 설명서 - 페이지 6

{카테고리_이름} Disc Makers Reflex1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers Reflex1 9 페이지. Dvd
Disc Makers Reflex1에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (6 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

2. Load the top drive (reader) with the master disc and load the lower drive

(writer) with high quality blank DVD-R, DVD+R, or CD-R media.

3. Press the "ENT" button to start the process. The unit will analyze the master

disc, and the source disc and display a message.

Upon successful testing the following will display on the LCD.

Test

OK: 01

If the target disc has already been written to, or is damaged and cannot be

written to, the LCD will display the message: "Target Drive Not ready"

If the data on the master CD will not fit on the target media then the LCD display

will read "Target Overflow".

3. T

EST AND

OPY

The test and copy function incorporates the first two functions into one opera-

tion. It is used to check whether a disc will successfully copy and then goes on

to do the copy. First, the copy process is simulated and then the data is actual-

ly copied to the recordable media.

1. Select the function using the up and down arrows.

2. Load the top drive (reader) with the master disc and load the lower drive

(writer) with high quality blank DVD-R, DVD+R, or CD-R media.

3. Press the "ENT" button to start the process. The unit will display test the

master disc, then check the target disc, and finally copy to the blank record-

able media.

Upon successful testing the following will display on the LCD.

Test and Copy

OK: 01

1-800-237-6666

If the target disc has already been written to, or is damaged and cannot be

written to, the LCD will display the message: "Target Drive Not ready"

If the data on the master disc will not fit on the blank target media then the LCD

display will read "Target Overflow".

4. V

ERIFY

The verify function is used to confirm that the master and the copy read the

same.

1. Select the function using the up and down arrows.

2. Load the top drive (reader) with the master disc and load the lower drive

(writer) with the recorded disc.

3. Press the "ENT" button to start the process.

Upon successful verification the following will display on the LCD and the

recorded media will be ejected. To verify another disc, place the next disc in the

writer drive and press the "ENT"button.

If the verification was unsuccessful the following will display:

5. C

OMPARE

The compare function takes the verify function one step farther, it gives details

about the master and recorded disc. It also, ejects the recorded disc upon a

successful comparison.

www.discmakers.com

Verify

OK: 01

Verify

F->

Fail: 01