Disc Makers ReflexPro4 사용자 설명서 - 페이지 6

{카테고리_이름} Disc Makers ReflexPro4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers ReflexPro4 15 페이지. Cd-r disc duplicator reflexpro series
Disc Makers ReflexPro4에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

The ReflexPro is a high performance CD-R disc duplicator designed for both the

novice and professional user. It is designed for a variety of applications that

require the exchange of audio, video or data content. The following is a User

Guide that outlines the menu commands of the unit and immediate functions

of the unit. For additional technical support please call 888-800-4041.

GETTING STARTED

Carefully remove the CD-R duplicator from its shipping container. Please

inspect the contents and verify them against the packing slip. Be sure to report

any errors in shipping immediately to Disc Makers.

Packing materials: Please save the original box and packaging in the event the

unit requires future service or you need to move the unit from one location to

another. This will help reduce the possibility of damage in transit.

Please Note: Any item that needs to be returned for a warranty repair must be

returned in original packaging.

NSTALLATION AND

ETUP

1. Unpack the ReflexPro to a clean and cool work area. Keep the external pack-

aging for future storage and transportation.

2. Place the ReflexPro on a flat, clean and dust free surface.

3. Connect the power cord from the back of the unit to an electrical outlet. Do

not bypass the Ground.

4. The Front panel should appear as below.

1-800-237-6666

ODES AND

ODES

The ReflexPro is able to duplicate in two different modes: hard drive to disc and

disc to disc. The unit is factory preset to hard drive to disc. This mode is effi-

cient for duplicating large numbers of discs. The hard drive to disc copies the

master to the hard drive and then copies the data to each of the drives. This

insures an exact copy of the original master to every disc.

The disc to disc mode will copy whatever is in the source (Src) drive to blank

media in the other drives in the unit. This mode is most effective for making

quantities of discs less than the number of drives in the unit. For the

ReflexPro4 if the need is for three discs or less, use the disc to disc mode. For

the ReflexPro7 if the need is for six discs or less, use the disc to disc mode.

Only slight changes will occur in the functions of the unit when the different

modes are chosen. When the unit is in the hard drive to disc mode 'P: A' will

appear at the right side of the first line of the LED. 'P' indicates the master disc

will be written to the hard drive and the next letter indicates which partition will

be written to.

ARD

RIVE TO

ISC

Upon powering up the ReflexPro the LCD screen should appear as below:

www.discmakers.com

OPYING

1. Copy

P:A