Disc Makers ReflexPro7 사용 설명서 - 페이지 8

{카테고리_이름} Disc Makers ReflexPro7에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disc Makers ReflexPro7 13 페이지. Cd-r disc duplicator reflexpro series
Disc Makers ReflexPro7에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (15 페이지)

페이지 인쇄

1. Installation and Setup

SUB FUNCTIONS

The Sub Functions provided in the Reflex are designed to allow the user to alter and

enhance the performance of the system according to their needs and applications. In

the main menu, press and hold down the STATUS button for five seconds. The menu will

be switched to the Sub Function menu. To return to the main Function menu and leave

the Sub Function menu, go to the SETUP mode and press and hold down the STATUS

button for five seconds.

Setup

Since there are different settings under the SETUP Sub Function to control the Reflex

operation, we suggest using the original default settings for optimal operation. Changes

should be made only when you are very familiar with its operation.

HDD Partition

This setting selects the current working partition on the internal hard drive. Press

the STATUS button to change the setting and press START to exit. After selecting a

partition, EXIT will bring you back to the COPY function in the main menu.

CD to CD

This setting controls the source location of the master data. Select YES to bypass the

existing hard drive and copy directly from CD to CD. Select NO to copy the CD from the

data stored in the current partition of the internal hard drive. This setting will not be

saved during the reboot of the Reflex. Press the STATUS button to change the setting

and the START button to exit.

Start Writers

This setting controls the number of CD writers that will work in the Reflex. Normally it

should be equal to the number of writers installed in the Reflex. However, the number of

writers set to record can actually be less than the number installed. If seven writers are

installed, for example, a number setting of "2" will allow using only two writers at one

time. The Reflex will start the operation instantly when any two of the seven installed

writers are ready (DISC DETECTED). The other five writers will be idle. Press the STA-

TUS button to change the setting and press the START button to exit.

Write Method

This setting controls the writing methods of the CD-R media INCLUDING DISC AT

ONCE or TRACK AT ONCE. DISC AT ONCE is the default setting. Press the STATUS

button to change the setting and the START button to exit.

Write Speed

This setting controls the maximum writing speed of the CD writers. The default

setting is MAX which will use the highest writing speed of the writers (40X). For

applications requiring a lower write speed, use this setting to adjust to 32X, 24X, 16X,

12X, 8X, 4X, or 2X. Press the STATUS button to change the setting and the START

button to exit.

www.discmakers.com

1-888-800-4041