Blade mCP X 사용 설명서 - 페이지 7

{카테고리_이름} Blade mCP X에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade mCP X 20 페이지.
Blade mCP X에 대해서도 마찬가지입니다: 사용 설명서 (18 페이지)

Transmitter and Receiver Binding

If you purchased an RTF model, the transmitter is bound to the model at the factory.

To bind or re-bind your mCP X to your chosen transmitter, please follow the directions below:

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique

Identifier) code of a single specific transmitter. You need to 'bind' your chosen Spektrum

technology equipped aircraft transmitter to the receiver for proper operation.

NOTICE: Use the Non-Computer Radio binding instructions if you are using a DX4e or DX5e transmitter

with the mCP X BNF.

Binding Procedure for Computer Radios:



1. Disconnect the flight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the flight battery to the helicopter. The 3-in-1 Control unit LED flashes after 5 seconds.

4. P ush in on the bind switch/button while powering on the transmitter.

5. A fter 2–3 seconds, release the bind switch/button.

6. M ove the rudder control stick to full right. Continue to hold the rudder control stick to full right until

the blue LED on the 3-in-1 control unit is solid.

7. R elease the rudder control stick.

8. Disconnect the flight battery and power the transmitter off.

The throttle will not arm if the transmitter's throttle control is not put at the lowest position and the stunt mode

switch is not in the 0 position.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other

instructions. If needed, contact the appropriate Horizon Product Support office.

For a list of compatible DSM transmitters, please visit www.bindnfly.com.



Binding Procedure for Non-Computer Radio (DX4e, DX5e)

1. Disconnect the flight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the flight battery to the helicopter. The 3-in-1 Control unit LED flashes after 5 seconds.

4. P ush in on the trainer switch or button while powering on the transmitter.

5. M ove the rudder control stick to full left after the transmitter LED lights flash twice.

6. R elease the trainer switch/button. Continue to hold the rudder control stick to full left until the blue

LED on the 3-in-1 control unit is solid.

7. R elease the rudder control stick.

8. P ush in on the trainer switch/button. The blue LED on the 3-in-1 control unit flashes to confirm the

helicopter is in non-computer mode.

9. Disconnect the flight battery and power the transmitter off.

If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer

transmitter mode; repeat binding procedure.

or JR

DSM

™