Cub Cadet 317-262-100 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Cub Cadet 317-262-100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet 317-262-100 20 페이지.
페이지 인쇄
opennnruc rne urur
Note: The snow thrower engine is designed to operate at cold tempera-
tures and will be difficult to start in warm weather. Avoid operating your
snow thrower in warmer conditions since engine may vapor lock and stop
running after a short time.
Never run the engine indoors or in enclosed, poorly
ventilated areas. Engine exhaust contains CARBON
MONOXIDE, an ODORLESS, DEADLY gas.
Pull Start Models: See figure 4.
1. Insert key in ignition switch and turn key to ON position.
2. Move choke control lever to the ON position on cold engines. lf the
engine is warm from operation, this step may not be necessary.
3. Push the primer button two or three times holding finger over
vent hole. Allow a few seconds between each push for air to
enter bulb through vent hole. You may have to prime more for
the initial start at temperature below 150F/-1OoC.
4. Grasp the starter rope handle and slowly pull out the rope until
you feel a resistance. Allow the rope to rewind slowly, then pul
it out rapidly to start the engine. Let the rope return slowly to
the starter. lf the engine does not start after three pulls, push
primer button one more time and pull the starter rope.
F I G U R E 4
- - - - '
5. Once the engine starts and gradually warms up, move the
choke lever to the OFF position. Be prepared to move the
choke lever to the ON position if the engine sputters during
warm up.
6. Allow the engine to warm up before snow throwing. The engine
will operate at full throttle when it warms uo.
Electric Start Model: See figure 5.
Note: Ihe electric starter is designed to operate on 120 votts AC
household power supply using the power cord supptied with your
snow thrower. When using the power cord, match the wide btade of
the plug to the wide slot of the receptacle.
7. Follow steps 1-3 from "pull start model" section.
B. Plug power cord into receptacle on the starter switch first, then
plug the other end of the cord into a standardl20 volts AC
household outlet. Do not use any extension cord to lengthen
the power cord supplied with the unit.
WARNING
STARTING
ENGINE
. Wear safety
glasses while
operating the
unit.
. Never direct
discharge at
bystanders or
allow anyone
in front of the
unit.
. Never direct
discharge
towards win-
dows.
. Neveroperate
the unit with-
out allguards,
clvens, and
shields in
place.
. Stop the
engine when-
ever leaving
the operating
position.
. Stop the
engine,
remove the
key, and dis-
connect the
spark plug
before unclog-
ging auger
housing or
discharge
chute and/or
before mak-
ing repairs or
adjustments.
. To reduce the
risk of fire,
keep the unit
clean and
free from
spilled gas, oil;
and other
I
debris.