Blade 350 QX2 사용 설명서 - 페이지 5

{카테고리_이름} Blade 350 QX2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade 350 QX2 18 페이지.

Charging the Flight Battery

Install the Gimbal

Install the Camera

Charger Speciﬁ cations

• Input Voltage: 10.5–15V DC

• Charge Current: 3.5A

1. Connect the AC power supply to the charger.

2. Connect the AC power supply to an AC power source.

The green LED blinks.

3. Connect the battery to the charger. The red LED

blinks, indicating charging. When the battery nears

full charge, the red and green LEDs blink, indicating

cell balancing.

4. Disconnect the battery when the green LED glows

solid.

LED Indications

Green Blinking: Ready to Charge

Red Blinking: Charging

Red & Green Blinking: Cell Balancing

Green Solid: Charging Complete

Red Solid: Error

NOTICE: If using a battery other than the included

Li-Po battery, refer to your battery manufacturer's

instructions for charging.

1. Slide the gimbal onto the mount as shown until it locks.

2. Connect the cable from the aircraft to the port on the

gimbal as shown.

1. Follow the instructions included with your camera to

charge the camera battery and install the micro SD

card (not included ).

2. Slide the camera fully into the gimbal as shown.

3. Insert the Wi-Fi antenna through the mount and into the

camera body until it clicks. Rotate the antenna 90° in

either direction to lock the antenna and camera to the

mount.

4. Install the 3mm mounting screw to secure the CGO1 to

the mount.

Refer to the included camera and gimbal manuals for

operating instructions.

The Battery Charging Process

CAUTION: Overcharging a battery can cause

a ﬁ re.