Blade 350 QX3 사용 설명서 - 페이지 8

{카테고리_이름} Blade 350 QX3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade 350 QX3 16 페이지.
Blade 350 QX3에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

Binding

The RTF/AP combo transmitter is bound to the model

at the factory. If for any reason the model needs to be

re-bound, follow the directions below.

Binding the 350 QX3 To Your Transmitter

1. With the transmitter and quadcopter powered OFF,

connect the battery to the 350 QX3.

2. Place the 350 QX3 on a ﬂ at level surface.

3. Power the 350 QX3 ON and let it initialize. The

status LED will remain off.

4. Hold the 350 QX3 upside down until the status LED

ﬂ ashes blue, indicating it has entered bind mode.

5. Set the quadcopter back upright.

6. On your transmitter, ensure the throttle is in the low

position and the throttle trim is at neutral.

7. Power ON your transmitter in bind mode according

to the instructions included with your transmitter.

8. When the binding process is successful, the

350 QX3 will emit a quick, 3-beep tone and the LED

will ﬂ ash either green, purple or red, depending on

which ﬂ ight mode is selected.

If the LED is ﬂ ashing red, the 350 QX3 is in Return

Home mode. Switch to Smart or AP Mode (green

or purple ﬂ ashing) before attempting to start the

motors.

9. Place the quadcopter outdoors in the desired

starting position in preparation for ﬂ ight.

Entering Bind Mode

Bind button

Normal Bind

Transmitter Bind Codes

Bind with GPS enabled

Bind with GPS disabled

Roll left

Roll right