Blade InducTrix 200 사용 설명서 - 페이지 12

{카테고리_이름} Blade InducTrix 200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade InducTrix 200 17 페이지.

페이지 인쇄

Replacing the Propellers

Follow the steps below to replace any damaged propellers:

1. Twist the top half of the protective cage of the affected

propeller counter-clockwise to unlock, and lift it to

remove the cage.

2. Remove 2 screws and remove the propeller by pulling

straight up.

3. Note the propellers are marked "A" or "B" to show the

proper location on the quadcopter. Using the illustration

as a placement guide, replace the propeller. Make sure

to line up the screw holes in the top of the motor with

the corresponding holes in the propeller.

4. Replace 2 screws. Do not overtighten the screws.

5. Line up the top protective cage tabs with the respective

slots in the propeller shroud. Twist the cage clockwise

until it locks into place.

Drift Calibration

The quadcopter has been calibrated at the factory before shipment, but it is possible that a crash will cause mechani-

cal distortion of the frame, resulting in a slight drift in the Stability modes. In this situation, please follow the calibration

procedure below.

Before beginning the calibration procedure, fully charge the ﬂ ight battery and ensure the quadcopter and transmitter are

bound properly, per the binding instructions.

To Calibrate the Blade Inductrix 200:

1. Power on the transmitter and quadcopter normally.

2. Refer to the

illustrations at

right. Depending

on which control

layout mode your

transmitter uses,

move the control

sticks to the

positions shown

and press the bind

button until the

LED on the

quadcopter

glows white

(approximately

3 seconds).

If you are using the DX6i transmitter, rather than pressing

the bind button, change the ﬂ ap switch to position 1 until

the LED on the quadcopter glows white.

3. Release the sticks and bind button.

4. Start the motors normally.

5. Slowly advance the throttle to bring the quadcopter into

Mode 2

6. Land the quadcopter by slowly lowering the throttle.

7. After landing, press the bind/panic button to complete the

Mode 1

DX6i users, change the ﬂ ap switch back to position 0.

a low hover. The LED will ﬂ ash continuosly to indicate

the calibration process has begun. Hold the hover for

approximately 15 seconds, using as little control input as

possible to keep the quadcopter steady.

calibration process. The LED will show solid blue.