Blade Inductrix200 사용 설명서 - 페이지 8

{카테고리_이름} Blade Inductrix200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Blade Inductrix200 17 페이지.

Installing the Flight Battery

1. Slide the battery into the back of the quadcopter,

as shown, until it locks.

2. To remove the battery, press the locking tabs on both

sides of the battery and pull the battery straight out the

back of the quadcopter.

CAUTION: Always remove the Li-Po battery

from the quadcopter when not ﬂ ying to avoid

over-discharging the battery. Batteries discharged to

a voltage lower than the lowest approved voltage may

become damaged, resulting in loss of performance and

potential ﬁ re when batteries are charged.

Powering On the Inductrix

1. Push the power button/LED once to power on the

quadcopter.

2. Push and hold the power button/LED for 1-2 seconds to

power off the quadcopter.

To bind or re-bind your quadcopter to your chosen transmitter, please follow the directions below.

General Binding Procedure

1. Refer the Transmitter Setup Table to correctly setup your transmitter.

2. Lower the throttle stick to the lowest position and center all trims on your transmitter.

3. Power off the transmitter and move all switches to the 0 position.

4. Install the ﬂ ight battery.

5. Press the quadcopter power button/LED. The quadcopter LED glows red, yellow or green, indicating the battery charge

level. The LED ﬂ ashes green and red brieﬂ y then continuously ﬂ ashes blue, indicating the quadcopter is in bind mode.

6. Put the transmitter into bind mode while powering on the transmitter.

7. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the LED on the quadcopter glows solid.

8. Press and hold the quadcopter power button/LED to power the quadcopter off. Power the transmitter off.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.

If needed, contact the appropriate Horizon Product Support ofﬁ ce. For a list of compatible DSM

please visit www.bindnﬂ y.com.

™

200 Quadcopter

transmitters,