Acorn Safety S0310-BF 설치, 작동 및 유지보수 지침 - 페이지 3

{카테고리_이름} Acorn Safety S0310-BF에 대한 설치, 작동 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Acorn Safety S0310-BF 5 페이지. Barrier free pedestal mounted eye/face washes

페이지 인쇄

Installation & Operation Manual

INSTALLATION INSTRUCTIONS:

Supplies required: ( Not provided by Acorn)

1. Wall Fasteners for signage mounting.

2. Pipe sealant or Teflon tape for sealing water connects.

IMPORTANT: FLUSH WATER SUPPLY LINES PRIOR TO

CONNECTION TO SAFETY EQUIPMENT.

NOTES:

Use hand tools and wrenches in a manner which will

prevent marring finished surfaces. Strap wrenches or

tools with plastic jaw linings are highly recommended.

Refer to Rough-In for location of supply and drain lines.

Fragments of Teflon tape or pipe sealant residue can

interfere with the proper operation of this unit. Ensure

pipe sealant methods do not cause contamination in the

system.

STEP ONE: PEDESTAL

1. Position center of pedestal flange "A" a minimum of 0'-9"

from left and rear wall. Position from center of flange "A"

a minimum of 0'-11" from right wall side wall.

2. While holding the flange in position, mark floor flange

mounting hole positions.

3. Remove the flange and install appropriate floor anchors

to receive mounting bolts (supplied by others).

4. Re-position the flange and install mounting bolts and

washers.

STEP TWO: UPPER VERTICAL ASSEMBLY

1. Assemble components "B, C, D, and A" in sequential

order using proper plumbing techniques to seal all made

up threads. Ensure that fittings are aligned and

perpendicular as shown.

STEP THREE: SUPPLY AND DRAIN CONNECTION

Note: Refer to Rough-In for supply line locations

1. Rough-In for pipe fittings to make connection to 1 1/4"

NPT drain connection "E" and 1/2" NPT valve inlet

connection "F".

STEP FOUR: TEST

1. Verify 1/2" supply valve inlet for the eye/face wash is

turned OFF.

2. Turn on potable water supply.

3. Inspect system for leaks.

4. Verify eye/face wash flows properly.

STEP FIVE: SIGNAGE

1. Position sign "G" with clear visibility, in close proximity to

safety equipment and mark mounting hole locations.

2. Select appropriate 1/4" anchors, screws and washers

(supplied by others) to install signage.

3. Attach inspection "H" tag, supplied, with plastic zip tie.

Acorn Safety

a division of Acorn Engineering

Manual #7109-105-001

MOUNTING SCREWS

AND HARDWARE TYP.

2X (PROVIDED BY

OTHERS)

MOUNTING SCREWS AND

HARDWARE TYPICAL 4X

(PROVIDED BY OTHERS)

Company

™

Page 3 of 5

WASTE LINE CONNECTION

FITTINGS ( PROVIDED BY

INSTALLER)

Revised: 05/06/13