Armytek Elf C1 Micro-USB 사용자 설명서 - 페이지 3

{카테고리_이름} Armytek Elf C1 Micro-USB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Armytek Elf C1 Micro-USB 4 페이지. Multi flashlight
Armytek Elf C1 Micro-USB에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지)

페이지 인쇄

Initial Service

TO SET/REPLACE BATTERY

1. Unscrew the tailcap.

2. Place the battery with the positive contact (+) facing the head of the

flashlight.

3. Adjust the tailcap and tighten it as far as it can go.

The flashlight is ready for operation.

FLASHLIGHT CHARGING

Turn off the flashlight and connect the cable. The color of the button

displays the charging stage: red – the flashlight is charging, green – the

flashlight is charged. If there is no indication, the battery is removed or

installed in the wrong polarity. Approximate time for charging a fully

discharged battery is 2 h 30 min. We recommend using adapters with

1A and higher.

Operation

Before use: Tighten the tailcap.

In OFF state:

1 click: To turn on the last used mode.

REV_00-0000

Press and hold: To start cycling through Firefly modes. Release to

select. Keeping button pressed will start cycling through Main modes.

In ON state:

1 click: To turn off the flashlight.

Press and hold: To start cycling through Main modes from any mode. In

Firefly1 cycling through Main modes starts after cycling through Firefly

modes. Release to select.

2 clicks: To turn on Turbo mode from any mode. The second double click

brings back last used mode.

MOMENTARY ACCESS

Firefly. Press and hold the button in OFF state to start cycling through

Firefly modes. Release to select. Keeping button pressed will start

cycling through Main modes.

Main. Short click from OFF state activates Main mode if it was the last

used mode.

Turbo. Double click in any mode in ON state. The second double click

brings back last used mode.

Cycling through Main modes. In ON state press and hold the button

in any mode. Main modes will start switching cyclically. In Firefly1

cycling through Main modes starts after cycling through Firefly modes.

Release to select.

Lamp mode. The flashlight can work without battery in Firefly1,

Firefly2 and Main1 modes. For this connect the Micro USB cable to the

flashlight and power source, remove the battery.

1 click: To turn on/off the flashlight.

Press and hold: To start cycling through modes.

Press and hold: To turn on Firefly1 mode [Section 1].

Automemorizing. After switching off the last used mode is memorized

for quick access at next switching on.

Lock-out function. Unscrew the tailcap to 1/4 for the protection from

accidental switching on.

Warning indication shows the battery level and the temperature

inside the flashlight.

Low battery level. When battery level is approximately <25%, the col-

or LED will show the warning level – flashing in orange color once in 2

second. With further voltage reduction brightness will start to decrease

in steps for safety of the battery and user. If brightness of the mode

(except Firefly modes and Main1) is approximately <25% from nominal

value, the main LED will flash 2 times. Critical battery level approxi-

mately <10% is indicated red once a second.

High temperature. When the temperature increases to the warning

level, the color LED flashes orange 3 times once in 2 seconds. At critical

level it flashes by red 3 times once in 1 second. Brightness starts to

reduce to safe level.

ELF C1 USER MANUAL ENG