Bladelius GRENDEL 지침 및 설치 설명서 - 페이지 6

{카테고리_이름} Bladelius GRENDEL에 대한 지침 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bladelius GRENDEL 9 페이지. Multi channel amplifier

Before connecting the AC-power cord to a live wall socket insure that all

inputs/outputs are connected first. Always disconnect the AC-power cord from

the live wall socket first, before disconnecting any cable from the amplifier. If

you must use an extension cord, select a heavy-duty cord of the type used for

large electrical appliances, such as an air conditioner AC-extension cord (16

AWG). We strongly recommend that you do not connect the amplifier's AC-

power cord to the accessory AC outlets on a preamplifier. Such convenience

outlets are not designed to supply the high-power levels that the Grendel

amplifier requires.

Fuse holder. There is a fuse holder near the AC-power cord. In the unlikely

event a fuse may need to be replaced, unplug the power cord from the wall.

Then remove all connections from the amplifier. Only replace the fuse with

the same type, size, and specification. Refer to "SPECIFICATIONS" at the

back of this instruction manual for the correct number, type and size of the

replacement fuse.

CAUTION: Failure to replace the fuse with the correct number, brand

name, and type listed in the "FUSE REPLACEMENT – PLEASE NOTE

CAREFULLY" chart, found in the back of this instruction manual under

section "Fuse Replacement Chart" will eventually lead to either another

blown fuse or amplifier damage.

Installation

(Physical)

Rack-Mount Installation:

Since the Grendel amplifier is quite heavy, we recommend that you mount the

Grendel amplifier as close to the bottom of a rack as possible to promote a

stable Rack-Mount installation. The Grendel amplifier needs special

consideration when rack-mounting to allow sufficient ventilation space all

around the amplifier. Thus we recommend one should allow at least a one-

rack-space below and above the amplifier as clearance, and that you allow

more than 2 to 3 inches (5 to 7.5 cm) of space on all six sides of the Grendel

amplifier.

Cooling

Please note that the Grendel amplifier is provided with cooling fans for forced

ventilation. Due to the amplifier being equipped with a switched power supply

with high efficiency the fans will only be activated under very extreme

conditions (or mounted in a confined space).

Installation

(Physical)

Shelf-Mount Installation: