Armytek Optoelectronics Prime C1 Pro 사용자 설명서

{카테고리_이름} Armytek Optoelectronics Prime C1 Pro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Armytek Optoelectronics Prime C1 Pro 2 페이지. Armytek prime pro flashlights user manual

페이지 인쇄

C2 Pro only: With ambient temperature +25°C the flashlight delivers light in Maximum mode for about 8-10 minutes and then the

brightness steps down to the Main3 mode. 40-60 seconds afterwards the brightness increases to the Maximum mode again. This

stepping goes cyclically to maintain the user's safety and the flashlight's functionality. In the conditions of good air-cooling the

flashlight delivers constant light even in Maximum mode. It does not use timers, but real active temperature measurements.

1. Always follow the instructions from this manual and recommendations on battery usage.

2. Apply only the recommended power sources.

3. Do not reverse battery polarity.

4. Do not use different power sources together, i.e. old ones with new ones, charged with

discharged. Do not use different types of batteries combined as the element with less

capacity can be damaged.

5. Do not modify or recast the flashlight and its components as it will deprive you of the

warranty.

6. Do not allow water or any other liquid to leak into the flashlight.

7. Do not aim a turned-on flashlight at people's or animals' eyes – it can cause temporary

blindness.

8. Do not allow children to use the flashlight without your assistance.

Armytek Optoelectronics Inc. shall not be liable for any harm done to the user if it

was caused by improper use of the product.

Care and Storage

It is recommended to clean the threads and O-rings off dirt and old grease. Remember that secure protection from water and dust

cannot be provided by worn out sealing. And fouling as well as lack of lubricant cause fast wear-out of threads and sealing rings.

To clean the threads do the following:

1. Unscrew the tailcap and remove the sealing ring carefully with a toothpick (do not use sharp metal things as they can damage the

ring).

2. Wipe the sealing ring thoroughly with a soft cloth (or tissue). Do not use solvents. If the sealing ring is worn out or damaged

replace it by a new one.

3. Clean the metal threads with a brush using ethanol. Be careful not to allow applied liquid to get inside the flashlight or tailcap as it

can cause fails in functionality of the flashlight.

After cleaning lubricate the thread and the sealing ring with polyalphaolefin-based silica grease, e.g. Nyogel 760G.The application of

automotive and other improper grease can cause swelling and damage of the sealing rings.

In case of active operation and exploitation in dusty environments, it is recommended to perform cleaning and lubricating of the parts

as often as required, even if it is more than twice a year.

Service and Warranty

Armytek provides free warranty repair for 10 years from the purchase.

Warranty doesn't cover damage caused by:

1. Improper usage.

2. Attempts to modify or repair the flashlight by nonqualified specialists.

3. Longtime application in chlorinated or polluted water, or other liquids (other than water).

4. High temperatures and chemicals' exposure (including the exposure of liquid from defected batteries).

5. Usage of low-quality batteries.

Armytek Optoelectronics Inc.

Web: www.armytek.com Email: [email protected]

Address: 67 Vandervoort Dr, Richmond Hill, Ontario, L4E 0C7, Canada

Specifications are subject to change without notice.

Warnings

Prime

THE MOST TECHNICALLY ADVANCED

FLASHLIGHTS IN THE WORLD

USER MANUAL

Thank you for choosing the products of Armytek Optoelectronics Inc., Canada.

Please read this manual carefully before using the flashlight.

Specifications

Armytek Optoelectronics Inc. is a Canadian manufacturer that produces powerful and reliable flashlights designed especially for your

needs applying in them components made in the USA and Japan.

Superb light of amazing constant brightness due to powerful electronics and active temperature control without timers

Efficient TIR-optics and no "tunnel vision" effect even after continuous use

Multicolor Warning Indication of low battery level and high temperature

Side switch for comfortable one-hand operation and easy modes switching with advanced operation

Multicolor State Indication and ultra low current drain in OFF-state - more than 25 years

Removable magnet in the tailcap, firm holster, removable clip, strong lanyard and possibility of tail-stand for multipurpose use

Compact and light-weight flashlight of guaranteed durability stands up harsh impacts and falling from 10 meters

Total protection from water, dirt and dust penetration - flashlight continues to work even at the depth of 10 meters

Model

Prime A1 Pro

LED

Optics

Brightness stabilization type

Light output, OTF lumens*

370

Peak beam intensity, candelas

3050

Hotspot/spill

Beam distance*

120 yards / 110 meters

Hotspot diameter at 330 feet / 100

meters

Firefly1: 0.15lm / 90d

Firefly2: 1.7lm / 200h

Modes and runtimes (measured for

Main1: 10 lm / 25h

Sanyo Eneloop AA 2000 mAh /

Main2: 70 lm / 3h

Armytek CR123A 1500 mAh / Armytek

Main3: 210 lm / 1.2h

18650 Li-Ion 3100 mAh to the

Max: 370 lm / 30min

decrease to 10% of initial brightness)

Strobe: 10Hz

Warning: 0.6Hz

1xAA /

Recommended power source

1x14500 Li-Ion

Length 4.14"/ 105mm,

Size

body diameter 0.96"/

24.5mm

Weight (w/o batteries)

2.22oz / 63g

* Light outputs for flashlights with Warm light are about 7% less, beam distances are about 3% less.

** C2 Pro: in Max mode Full stabilization is for 20 minutes, then it is Step.

We recommend to use Sanyo Eneloop AA rechargeable batteries instead of ordinary AA batteries to obtain higher brightness

and longer runtimes.

10 years no-hassle warranty

Prime A2 Pro

Prime C1 Pro

Prime C2 Pro

Cree XM-L2

TIR

FULL stabilization (constant brightness)**

500

400

1050

4250

3100

8800

20°/ 80°

142 yards / 130 meters

121 yards / 111 meters

206 yards / 188 meters

16 meters

Firefly1: 0.2lm / 100d

Firefly1: 0.15lm/130d

Firefly2: 2lm / 18d

Firefly2: 1.7lm / 300h

Firefly3: 15lm / 72h

Main1: 10 lm / 48h

Main1: 10 lm / 40h

Main1: 70lm / 18h

Main2: 70 lm / 9.5h

Main2: 70 lm / 5h

Main2: 200lm / 9h

Main3: 210 lm / 2.5h

Main3: 210 lm / 2h

Main3: 420lm / 3.8h

Max: 500 lm / 1h

Max: 400 lm / 35min

Max: 1050lm / 1.5h

Strobe: 10Hz

Warning: 0.6Hz

1xCR123A /

1x18650 Li-Ion /

2xAA

1xR123 Li-Ion

2xCR123A/2xR123 Li-Ion

Length 5.95"/ 151mm,

Length 3.50"/ 89mm,

Length 4.73"/ 120mm,

body diameter 0.96"/

24.5mm

2.26oz / 64g

2.19oz / 62g

2.05oz / 58g