ABBAKA Range Hood & Hy-Ex Ventilation System 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} ABBAKA Range Hood & Hy-Ex Ventilation System에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABBAKA Range Hood & Hy-Ex Ventilation System 11 페이지. Range hood & hy-ex ventilation system

페이지 인쇄

NOTE: Make all connections in accordance with local codes.

Switch power off at service panel and lock the service discon-

necting means before wiring the unit. Detailed instructions

for electrical connection to the remote ventilator will be pack-

aged with the ventilator. Power cables, connectors, conduit

etc. not supplied.

Wiring the Hy-Ex Remote Ventilator HYEX-1.4 or 1.O:

1. Run three #14 AWG wires (black, white and green) in

conduit from the remote ventilator to the hood.

2. Remove ventilator's top cover.

3. Feed conduit through the knock out into the base of the

ventilator. Secure with an appropriate connector.

Duct

Hood Stack

Wiring from Service Panel

1. A 15A circuit is required for installation. It is recom-

mended to dedicate the circuit.

2. Run three #14 AWG wires: (black, white and green) in

conduit from service panel to hood.

3. Make the electrical "whip" long enough to reach the coun-

tertop below the installed hood.

Wiring at the Hood:

Refer to Page 9, "Wiring At Hood/Liner Re-Installation & Sys-

tem Test.

4. Connect wires to the

terminal block inside the

Flexible

ventilator; connect Black

Metal

to terminal labeled LINE/

Conduit

Black, White to NEU/

White terminal and Green

to GND/ Ground termi-

nal. Replace ventilator's

cover.

5. Run the 3-wire bun-

dled conduit from the ven-

tilator to the hood. Make

the electrical "whip" long

enough to reach to the

countertop below the in-

stalled hood.

Electrical/Liner Installation

Hoods Using Hy-Ex Remote Ventilator

120VAC

Hood Shell

Liner

Hy-Ex Remote Ventilator

Motor Speed

Control

Liner Knock-out

Top View

Supply Knock-Out

Ventilator Switch

Leg Knock-Out