Cub Cadet CC 2000 운영자 매뉴얼 - 페이지 18
{카테고리_이름} Cub Cadet CC 2000에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet CC 2000 20 페이지. 2-cycle trimmer
Cub Cadet CC 2000에 대해서도 마찬가지입니다: 부품 목록 (2 페이지)
Section 7
Troubleshooting
CAUSE
On/Off Stop Control is in STOP position
Empty fuel tank
Primer bulb wasn't pressed enough
Engine flooded
Old or improperly mixed fuel
Fouled spark plug
Plugged spark arrestor
ACTION
Turn On/Off Stop Control to START
Fill fuel tank with properly mixed fuel
Press primer bulb fully and slowly 5-7 times
Use starting procedure with choke lever in the
RUN position, Pg. 10
Drain gas tank / Add fresh fuel mixture
Replace or clean the spark plug
Clean or replace spark arrestor
CAUSE
Air Filter is Plugged
Old or improperly mixed fuel
Improper carburetor adjustment
ACTION
Replace or clean the air filter
Drain gas tank / Add fresh fuel mixture
Adjust per instruction Pg. 16
CAUSE
Old or improperly mixed fuel
Improper carburetor adjustment
Cutting attachment
bound with grass
Dirty air filter
Plugged spark arrestor
ACTION
Drain gas tank / Add fresh fuel mixture
Take to an authorized service dealer for
carburetor adjustment
Stop the engine and clean the cutting attachment
Clean or replace the air filter
Clean or replace spark arrestor
CAUSE
Old or improperly mixed fuel
Improper carburetor adjustment
Fouled spark plug
Plugged spark arrestor
ACTION
Drain gas tank / Add fresh fuel mixture
Take to an authorized service dealer for
carburetor adjustment
Replace or clean the spark plug
Clean or replace spark arrestor
CAUSE
Cutting attachment
bound with grass
Cutting attachment
out of line
Inner reel bound up
Cutting head dirty
Line welded
Line twisted when refilled
Not enough line is exposed
ACTION
Stop the engine and clean cutting attachment
Refill with new line
Replace the inner reel
Clean inner reel and outer spool
Disassemble, remove the welded section
and rewind the line
Disassemble and rewind the line
Push the Bump Knob and pull out line until
4 inches (102 mm) of line is outside of the
cutting attachment
18