Cub Cadet CC 3000 운영자 매뉴얼 - 페이지 13

{카테고리_이름} Cub Cadet CC 3000에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet CC 3000 20 페이지. C-cycle trimmer

페이지 인쇄

Maintenance (continued)

Fig. 6-1

Spring _

Inner Reel _

Bump Knob

Bolt

Indexing Teeth

Fig. 6-2

For Use with

For Use with Membrane

Single Line ONLY

Line or Single Line

>So

Holes

Fig. 6-3

Fig. 6-4

LINE INSTALLATION

This section covers both Membrane line and standard

single line installation.

Always use manufacturer's

0.105 inch (2.67 mm)

replacement line. Line other than specified may make

the engine overheat or fail.

Never use metal-reinforced

line, wire, chain, or

rope, etc. These can break off and become a

dangerous

projectile.

There are two methods to replace the trimming line.

• Wind the inner reel with new line

• Install a prewound inner reel

Winding the Existing Inner Reel

Hold the outer spool with one hand and unscrew

the Bump Knob clockwise

(Fig. 6-1). Inspect the

bolt inside the Bump Knob to make sure it moves

freely. Replace the Bump Knob if damaged.

Remove the inner reel from the outer spool

(Fig. 6-1).

Remove spring from the inner reel (Fig. 6-1).

Use a clean cloth to clean the the inner reel, spring,

shaft, and inner surface of the outer spool.

Check the indexing teeth on the inner reel and

outer spool for wear (Fig. 6-2). If necessary, remove

burrs or replace the reel and spool.

NOTE: Membrane

line can only be used with the

inner reel with the slotted

holes. Single line can be

used on either type of inner reel Use figure 6-3 to

identify the inner reel you have.

NOTE: Always use the correct line length when

installing trimming

line on the unit. The line may

not release properly if the line is too long.

Single Line Installation

Go To Step 8 for Membrane Line Installation

6. Take approximately

30 feet (9.1 m) of new trimming

line, loop it into two equal lengths. Insert each end

of the line through one of the two holes in the inner

reel (Fig. 6-4). Pull the line through the inner reel so

that the loop is as small as possible.

Wind the lines in tight even layers, onto the reel

(Fig. 6-5). Wind the line in the direction indicated on

the inner reel. Place your index finger between the

two lines to stop the lines from overlapping.

Do not

overlap the ends of the line. Proceed to step 11.