Discount Car Stereo JAG-HF 빠른 시작 매뉴얼 - 페이지 9
{카테고리_이름} Discount Car Stereo JAG-HF에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo JAG-HF 10 페이지. Bluetooth kit for jaguar xk and xj with cd changer
Discount Car Stereo JAG-HF에 대해서도 마찬가지입니다: 빠른 시작 블루투스 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (10 페이지)
페이지 인쇄Bluetooth operation
Turn ignition to ACC position and radio ON.
1.
Press "CD" button on radio. Track or Disc number displayed only if they are
2.
disc in magazine otherwise "NO MAGAZINE" is displayed (See Fig. 27)
Radio must be in "CD Mode" when using the JAG-HF.
connected but will no longer play.
Use radio button to adjust playback level and tone controls.
3.
Music Commands
To
Pause a Song
Resume Play
Skip to next song
Skip to Previous Song
Activate Aux input*
Activate Voice Control
Switch from Aux to Streaming Audio
Fig. 27
CD Changer remains
Proceed this way
Press and release button
Press and release button
Press button twice
Press button three times
Press button four times
Press/hold button for 2 seconds
Press and release button
Phone Commands
To
Answer call
End call
Reject incoming call
Cancel outgoing call
Activate Voice Control
Notes:
If audio playback is distorted or low, adjust volume on phone.
1.
To reset Module, press and Hold button for 5 seconds (this will not
2.
un-pair phone or erase stored phones)
Bluetooth range is approximately 30 ft. make sure device is within
3.
range of receiver
Voice command compatible with Apple (Siri), Android (Google Now),
4.
Blackberry (Assistant)
*Audio controls not applicable in Aux mode. Use the Aux device built-in
5.
control for music selection and controls.
If successful proceed to reverse the removal steps for Amp rack and center
glovebox console and secure the control button/microphone to dash as per step
#6 in "installing Bluetooth module" instructions.
Congratulations, you've just updated your vehicle to support new technology
while preserving the original radio and dash components.
Enjoy!
Proceed this way
Press and release button
Press and release button
Press button twice (call goes to VM)
Press button twice
Press/hold button for 2 seconds