BLADEZ VeloPro HW3018B 소유자 매뉴얼 - 페이지 13

{카테고리_이름} BLADEZ VeloPro HW3018B에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BLADEZ VeloPro HW3018B 19 페이지. Cycle trainer
BLADEZ VeloPro HW3018B에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

페이지 인쇄

Getting familiar with the control panel

XLG EXERCISE COMPUTER-

SPECIFICATIONS :

TIME..................................................................00:00-99:59 MIN:SEC

SPEED....................................................... .....0.0- 999.9KM/H or ML/H

DISTANCE................................................................0 - 999.9 KM or ML

CALORIES......................................................... ...........0- 999.9KCAL

KEY FUNCTIONS:

MODE: To select a desired function. Hold the key for 4 seconds to have all function values

reset to zero (0) - total reset

SET: To input the target value.

RESET: To let the value reset.

KM/ML SWITCH ：Switch the unit to KM or ML

Follow the steps below to change measurement unit to English or metric

1) Remove batteries then set the switch to

2) Install batteries

OPERATION PROCEDURES:

AUTO ON/OFF

To conserve power, the monitor will automatically shut off if there is no speed signal sensed

or no key pressed in 4 minutes. The monitor will be auto-powered when the exercise begins

or at any key press

Displays work out time lapse while exercising.

<1>TIME

Displays the current speed.

<2>SPEED

Accumulates the distance while exercising.

<3>DISTANCE

<4>CALORIES

Displays calories consumed while exercising.

Scans through each function between: TIME-

<5>SCAN

SPEED-CALORIES-DISTANCE.

BATTERY

If there is an improper display on the monitor, Please

replace or change for new batteries. This monitor uses

two "AA" batteries. Always replace both batteries at the

same time.

Operation of the Monitor

ON(

2007 K/M

) for Mile

OFF(

) for KM