Discount Car Stereo IP-BKR2 빠른 시작 설치 매뉴얼 - 페이지 3

{카테고리_이름} Discount Car Stereo IP-BKR2에 대한 빠른 시작 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo IP-BKR2 6 페이지. Becker aux ready radios

Radio connectors

Warning: BLUE and GREEN plugs are for optional CD changer and if

present, both must be disconnected. YELLOW plug is reserved for

amplifier and if present must remain connected

4. Connect adapter BLUE and GREEN plugs to C-2 and C3 chamber (See

Fig. 3)

5. Carefully route 30-pin dock terminal (See Fig. 4) to glove box, center

dash or location where the audio device will reside.

Apple 30-pin dock connector

Fig. 4

Fig. 3

Enabling AUX mode

One of the most important steps in this process is enabling the Becker radio

AUX menu option. Most Becker radios are pre-programmed to recognize a CD

Changer connection and because of that you must perform the following steps

and change the setting to "AUX" otherwise the radio will not recognize the newly

installed adapter. See radio listing below to determine AUX enabling steps.

Radios with TP button: (i.e. CDR-220)

Turn radio "ON"

2. Press and hold "TP" button for about 8 seconds until Becker 1 is

displayed.

3. Turn tuning knob until AUX OFF is displayed.

4. Press either button located directly under the arrows on the display to

change present setting from OFF to ON.

Turn radio OFF.

5. Turn radio back ON, press the "S" (Source) button to enter AUX Mode.

This is the mode to use whenever you want to listen to audio device