Discount Car Stereo A2D-C5 빠른 시작 설치 매뉴얼 - 페이지 2

{카테고리_이름} Discount Car Stereo A2D-C5에 대한 빠른 시작 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo A2D-C5 12 페이지. For 1997-04 corvette with functioning 12-disc cd changer
Discount Car Stereo A2D-C5에 대해서도 마찬가지입니다: 설치 매뉴얼 (10 페이지)

페이지 인쇄

Introduction:

If your C5 has a functional 12-disc changer and looking to add music streaming; the

A2D-C5 is for you! Users may opt to connect module to radio or 10-pin CD

changer plug at changer location in hatch/trunk. The required 12-disc CD

changer remains connected and operational; however,

changer malfunctions, so will this module. Purchase our

Simply pair smartphone or tablet to module and enjoy GPS prompts, Apple music,

Pandora and more on the car system. All controls and display remain with audio

device – C5 radio controls (except volume button) do not apply.

See Frequently Asked question at the end of this guide.

Installation 1:

(To Radio using the PXHGM4 harness)

The PXHGM4 harness connects module to radio. The

PXHGM2 harness connects module at the cd changer

location.

Click links below for radio removal video)

Radio removal required. (

https://www.youtube.com/watch?v=Gcrlufo1ctc

https://www.youtube.com/watch?v=WTbWYNJTSDs

Press black release tab to disconnect 20-pin plug from radio. (See Fig. 1)

If vehicle 12-disc

BLU-C5

instead.

Fig. 1

2. Connect factory 20-pin plug (from step 1) to installation harness matting

20-pin white connector (See Fig. 2).

PXHGM4 installation harness

3. Connect installation harness 20-pin black/gray plug (See Fig. 2) to radio

20-pin connector vacated in step 1

Revision (4.6.20)

Applies to installations at radio with PXHGM4 or PXHGM4 + USB harnesses.

What's new:

1. Streaming is now possible up and until radio turns off. (Previous revision

would turn on/off with ignition switch).

2. No longer requires routing accessory wire to fuse

added to the aforementioned harnesses Skip to "pairing" on page 6.

Warning:

Revision 4.6.20 does not apply to installs in trunk/hatch using the

PXHGM2 harness- these still require routing accessory wire to fuse panel,

Skip to "installation 2" on page 4

Modules purchased prior revision (4.6.20); proceed to step 4 below.

4. Connect (Tap) installation harness red wire to an ACC (Accessory or

switched) 12V supply power source in vehicle.

Fig. 2

panel.

Special circuit