Discount Car Stereo Becker Radio 빠른 시작 설치 매뉴얼 - 페이지 3

{카테고리_이름} Discount Car Stereo Becker Radio에 대한 빠른 시작 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo Becker Radio 6 페이지. With aux menu option

To install our iPod adapter: Connect the blue plug to C-3 chamber and

green plug to C-2 chamber (See Fig. 3)

Warning!

Auxiliary input adapters do not have a Green plug

however; if the Becker radio has a CD Changer connection, both the

Green and Blue plugs must be disconnected otherwise the AUX

adapter will not work properly.

Carefully route Adapters Terminal (30-pin dock or 3.5mm) (See Fig. 4)

to glove box, center dash or location where the audio device will

reside.

Apple 30-pin dock connector 3.5mm (1/8") Audio plug

Fig. 4

Operation:

One of the most important steps in this process is enabling the Becker Radio

AUX Menu option. Most Becker radios are pre-programmed to recognize a CD

Changer connection and because of that you must perform the following steps

and change the setting to "AUX" otherwise the radio will not recognize the newly

installed adapter.

Enabling the AUX function

Radios with TP button: (i.e. CDR-220)

Turn radio "ON"

2. Press and hold the "TP" button for about 8 seconds until Becker 1 is

displayed.

3. Turn the Tuning Knob until AUX OFF is displayed.

4. Press either button located directly under the Arrows on the display to

change the present setting from OFF to ON.

Turn radio OFF.

5. Turn Radio back ON, press the "S" (Source) button to enter AUX Mode.

This is the mode to use whenever you want to listen to the device

connected to the adapter.