BLADEZ ION 150 제품 핸드북 - 페이지 7

{카테고리_이름} BLADEZ ION 150에 대한 제품 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. BLADEZ ION 150 13 페이지. Electric power board
BLADEZ ION 150에 대해서도 마찬가지입니다: 문제 해결 절차 (12 페이지)

페이지 인쇄

BOX CONTENTS

Your Bladez ION should come complete with:

1. Bladez ION 150 ELECTRIC POWER BOARD

2. AC Wall Charger

3. Allen Wrench

4. Instruction Manual and Registration Card

GETTING STARTED

YOUR SCOOTER WILL COME CHARGED OUT OF THE BOX BUT YOU MUST

CHARGE YOUR ION 150 FOR 6-8 HOURS EVEN IF BOTH LIGHTS ON THE

CHARGER ARE GREEN PRIOR TO FIRST USE!

Before You Ride

* Note: It is not advisable to operate your Power Board with low tire pressure. This will negatively affect

speed, handling and performance.

Fig. 1

1. The ION is shipped with the Handlebars

unattached.

2. You need to insert the accelerator and

brake levers into the handlebars. To insert,

remove the screws from the handlebar,

then insert the right and left handle and

align the holes. (Fig.1). Then insert the

screws through the holes and tighten the

nuts. (Fig. 2).

3. *Note: The Accelerator Lever (the one

with the shorter lever) goes on the right,

the Brake Lever goes on the left.

Fig. 2

4. Make sure all of the bolts are tightened.

Also make sure to insert the bolts in the

correct way with the nuts on the back side

of the handlebars as in Fig. 2

5. Make sure the front tire is inflated to 40 PSI

as the tire may lose pressure during

shipping. For information on inflating the

tire, please refer to page 10. The rear tire is

solid rubber.