BLADEZ ION 450 핸드북 - 페이지 12

{카테고리_이름} BLADEZ ION 450에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. BLADEZ ION 450 16 페이지. Electric power board

RECOMMENDED TOOLS

To adjust and service the Bladez ION 450 Power Board the following additional tools

may be helpful:

Allen Keys:

Wrenches:

Philips & Flat Head Screwdrivers

Hand bicycle pump

Oil, Grease or Lubricant (such as WD-40)

The ION 450 uses a rear wheel drum brake system activated by a hand lever (on the

left side of the handlebar). The brake is activated by squeezing the BRAKE LEVER with

your left hand. The ION 450 is equipped with a controller that temporarily disengages

the power to the motor when the BRAKE LEVER is depressed.

Practice braking on a smooth, dry surface to get used to the feel of the braking system.

Braking distance is affected by wet conditions and loose and uneven riding surfaces.

The brakes are relatively maintenance free and come adjusted to the proper setting

from the factory.

It is recommended that front and rear tires be inflated to 35 P.S.I. During shipping, the

tires might become slightly deflated.

To Inflate the Tires

6mm.

16 / 17mm Open and ring combination.

1. Remove the valve stem cover to expose the

valve stem. (FIG. 10, 11)

2. Using a standard bicycle pump, inflate the

tires to 35 P.S.I. and replace the valve stem

cover. It is also recommended to use a tube

additive like Slime available from any

motorcycle shop, to avoid inconvenient

punctures.

WARNING: Injury can occur if you

fail to release the air from the tire.

The Bladez ION 450 uses an identical rim

and tire assembly for the front and rear

Page 11