BLADEZ PB-SM 818 제품 핸드북 - 페이지 14

{카테고리_이름} BLADEZ PB-SM 818에 대한 제품 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. BLADEZ PB-SM 818 15 페이지. Electric power board

페이지 인쇄

TROUBLESHOOTING GUIDE

The following guide will help assist you in identifying and correcting common problems with your XTR-

COMP II:

Symptoms

The charger light turns green

right away

Batteries do not hold a charge.

Unit does not have specified

travel range.

Unit moves intermittently, or very

slow.

Unit will not move when throttle

lever is activated.

Unit stops abruptly during use.

NOTE: You may also refer to the multi-function LED section on page 9 for further trouble

shooting.

OTHER QUESTIONS

Where can get replacement and aftermarket parts?

From your local Servicing Dealer or on the web at:

www.ebladez.com

For additional questions, service instruction, further information and important phone numbers, please go

to the Bladez website at www.ebladez.com.

If you have any additional questions, please contact Bladez Customer Service Department at

(866) 325-2339

Thank you for purchasing a Bladez Power Board and please tell your friends about how much fun you

had on the Bladez Power Board.

Potential Causes:

This indicates the batteries are

adequately charged. Most units

come charged in the box.

Batteries have reached the end

of their useful life or poor polarity

between batteries.

Charger is malfunctioning.

Batteries not fully charged or

polarity problem.

Throttle cable is loose.

Batteries won't fully charged.

Batteries have reached the end

of their useful life.

Circuit breaker has "tripped".

Page 14

Solutions:

Continue to charge the batteries

for 6-8 hours prior to initial use.

Replace batteries.

Replace charger unit.

Charge or replace batteries.

Tighten cable.

Replace batteries or charger

Replace batteries.

Allow electric motor to cool and

re-set circuit breaker by turning

power switch on and off.