BLADEZ PB-SM806 제품 핸드북 - 페이지 14

{카테고리_이름} BLADEZ PB-SM806에 대한 제품 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. BLADEZ PB-SM806 16 페이지. Electric power board

CHAIN CARE

Proper chain care will increase the life and improve performance of your Power Board. Always

keep the chain lubricated and tightened to proper tension.

Always keep the chains lubricated with a good chain spray or grease (not chain wax). If the

chains are allowed to run dry for a prolonged period they will fail, and the life of the chain is

severely shortened.

The chain on the Power Board should be adjusted from time to time. The chain should be

tight enough not to skip, but have a little bit of play. If you feel your chain skipping or make a

popping noise, adjust the tension immediately.

For regular adjustments:

1. Using a 16mm wrench, loosen the axle bolts on each

side of the rear wheel (Fig. 11).

2. While the axle bolts are loose, using a 10mm wrench

loosen the tension bolts behind the rear wheel of the

Power Board and move the rear wheel backwards to

remove the slack for the chain (fig. 12).

3. Once this is achieved the wheel nuts must then be

relocked into position and wheel alignment must be

checked (while turning the wheel, visually check that

the clearance between the wheel and the frame parts

have clearance).

*Note: Chains that are run excessively dry or loose

can result in sprocket teeth being severely

damaged.

Page 14