Discount Car Stereo BLU-C5 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Discount Car Stereo BLU-C5에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo BLU-C5 12 페이지. Music streaming module for seelect 1997-04 corvette
Discount Car Stereo BLU-C5에 대해서도 마찬가지입니다: 설치 매뉴얼 (9 페이지), 설치 지침 (12 페이지), 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (12 페이지)

페이지 인쇄

Important wiring revision (4.6.20) update:

Installing at the radio (with either the PXHGM4 or PXHGM4 + USB harness);

allows module to turn on/off with radio PWR button (instead of ignition switch)

which means streaming will continue to play until radio is turned off. In addition;

routing

accessory wire to fuse panel is no longer required.

on page 6. (Revision does not apply to installs in trunk/hatch with PXHGM2

harness- these still require wire routing to fuse panel)

Modules purchased prior to revision (4.6.20); proceed to "where to get

12V ACC/Switched power" below

New version 4.6.20

Where to get 12V ACC/Switched power?

1997-03: Look for 3-pin harness under passenger toe board (may be

covered in black duct tape) – Yellow wire is ACC (See Fig. 5) otherwise

Alternate 12V Acc. Supply on next page.

Note: 3-pin harness is not be present and was omitted in 2004.

Skip to "pairing"

Radio power button

go to

Fig. 5

Alternate 12V Acc. supply:

We recommend taping fuse #22 or #11 of interior fuse box

which is located under passenger toe board next to BMC (See Fig. 5).

circuit seen in Fig. 6 is included for this purpose.

Add-a-fuse

mini-tap

fuse tap circuit

How to use the Add-a-fuse circuit connection

a. Strip 1/4- 3/8" insolation from included accessory wire.

b. Look inside blue connector to see where metal ends. Useful in step d.

c. Insert stripped wire to blue connector (See Fig. 6)

d. Hold wire in place and crimp down (crimping tool, plyers etc.) After

crimp, pull on wire to verify crimp integrity.

e. Remove fuse #22 or #11 (if present) from vehicle fuse box otherwise

skip to step g.

Insert factory fuse to empty slot on add-a fuse circuit

g. Insert add-a-fuse circuit to fuse slot #22 or# 11

Noteworthy: If there is no fuse in slot #22 or #11, empty slot on add-a-fuse

remains empty. With ignition "ON" verify module blue LED is flashing, otherwise

check voltage at fuse slot and/or check add-a fuse crimp integrity,

Fig. 6