Discount Displays STDRD-MONITOR STAND 설정 지침 - 페이지 3

{카테고리_이름} Discount Displays STDRD-MONITOR STAND에 대한 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Displays STDRD-MONITOR STAND 3 페이지.

SECURING AND LEVELING THE FRAME

Step 1: Attach the Eye Nut with Wing Bolt (K) through the hole in the center of

the top Horizontal Support (C).

Step 2: Attach the Eye Bolt (L) to the base at the screw hole insert located at

the back.

Step 3: Connect the Tension Wire (M) - First, the the Carabiner to the top Eye

Nut (K) and then the Tension Screw to the Eye Bolt (L) on the base.

Step 4: Turn the middle of the tension screw until the wire is tight and the

display frame is level.

ASSEMBLING AND MOUNTING THE HEADER GRAPHIC

Step 1: Connect the tubing segments that are bungee corded together. Each

locking push pin should snap in place.

Step 2: The "T" shaped pieces slide into the two holes located closest to the

inside of the frame.

Step 3: Unzip the fabric graphic and slide over the tubing frame so the graphic

faces forward (convex side).

Step 4: Zip graphic closed around the outside edge making sure that the "T"

tubes protrude through the holes on the back (concave side) of the graphic.

Step 5: Slide the angled tube supports onto the ends of the "T" tubes protrud-

ing through the graphic and tighten with wing nuts.

Step 6: Slide the angled tube supports into the plastic holes at the top of

the frame.

STDRD-MONITOR STAND