Discount Equipment KL-14 매뉴얼 - 페이지 3

{카테고리_이름} Discount Equipment KL-14에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Equipment KL-14 12 페이지. 14” compact saw
Discount Equipment KL-14에 대해서도 마찬가지입니다: 운영자 사용 설명서 (16 페이지)

페이지 인쇄

E-KL14-PL-1015

READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY

Death or serious injury could occur if this machine is used improperly.

SAFETY

SAFETY MESSAGES

MESSAGES

Safety Instructions are proceeded by a graphic alert symbol

of DANGER, WARNING, or CAUTION.

Indicates an imminent hazard which, if not

avoided, will result in death or serious injury.

Indicates an imminent hazard which, if not

avoided, can result in death or serious injury.

Indicates hazards which, if not avoided, could

result in serious injury and or damage to the

equipment.

GASOLINE/PROPANE POWERED EQUIPMENT

Engine exhaust from this product contains

chemicals known to the State of California to

cause cancer, birth defects or other reproduc-

tive harm.

It should only be dispensed in well ventilated areas,

and with a cool engine.

Small gasoline engines produce high concentra-

tions of carbon monoxide (CO) example: a 5 HP 4 cycle

engine operation in an enclosed 100,000 cu. ft. area with

only one change of air per hour is capable of providing

Five changes of air in the same area will produce noxious

fumes in less than 30 minutes. Gasoline or propane pow-

ered equipment should not be used in enclosed or partially

enclosed areas. Symptoms of CO poisoning include, head-

ache, nausea, weakness, dizziness, visual problems and

loss of consciousness. If symptoms occur - get into fresh

air and seek medical attention immediately.

ELECTRICAL POWERED EQUIPMENT

Extreme care must be taken when operating electric

models with water present: Ensure power cord is prop-

erly grounded, is attached to a Ground-Fault-Interrupter

(GFI) outlet, and is undamaged.

Check all electrical cables - be sure connections are tight and

cable is continuous and in good condition. Be sure cable is

correctly rated for both the operating current and voltage of

this equipment.

Improper connection of the equipment-grounding conductor can

cian or service person if there is any doubt as to whether the

outlet is properly grounded. Adhere to all local codes and

ordinances.

NOTE: In the event of a malfunction or breakdown, grounding

provides a path of least resistance for the electric current to

dissipate. The motor is equipped with a grounded plug and

must be connected to an outlet that is properly installed and

properly grounded. DO NOT modify the plug provided on the

cian install the proper receptacle.

Switch motor OFF before disconnecting power.

Printed in USA

KJK

Page 2

BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT.

Do not disconnect power by pulling cord. To disconnect, grasp

the plug, not the cord.

Unplug power cord at the machine when not in use and before

servicing.

GENERAL INSTRUCTIONS

Equipment should only be operated by trained personnel in

good physical condition and mental health (not fatigued). The

operator and maintenance personnel must be physically able

to handle the bulk weight and power of this equipment.

This is a one person tool. Maintain a safe operating distance

to other personnel. It is the operators' responsibility to keep

other people (workers, pedestrians, bystanders, etc.) away

during operation. Block off the work area in all directions with

roping, safety netting, etc. for a safe distance. Failure to do so

them to harmful dust and noise.

This equipment is intended for commercial use only.

For the operator's safety and the safety of others, always keep

all guards in place during operation.

Never let equipment run unattended.

Personal Protection Equipment and proper safety attire must

be worn when operating this machinery. The operator must

wear approved safety equipment appropriate for the job such

as hard hat and safety shoes when conditions require. Hear-

ing protection MUST be used (operational noise levels of this

equipment may exceed 85db). Eye protection MUST be worn

at all times.

Keep body parts and loose clothing away from moving

parts. Failure to do so could result in dismemberment

or death.

Do not modify the machine.

Stop motor/engine when adjusting or servicing this equipment.

materials. Sparks from the cutting-action of this machine

Some dust created by power sanding, sawing,

grinding, drilling, and other construction activi-

ties contains chemicals known to cause cancer,

birth defects, or other reproductive harm. Some

examples of these chemicals are:

Lead from lead-based paints, and

Crystalline silica from bricks and concrete and other

masonry products.

Your risk of exposure to these chemicals varies depending

on how often you do this type of work. To reduce your risk:

work in a well ventilated area, use a dust control system, such

as an industrial-style vacuum, and wear approved personal

safety equipment, such as a dust/particle respirator designed

DUST WARNING