Arnica BORA 5000 운영 매뉴얼 - 페이지 10
{카테고리_이름} Arnica BORA 5000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arnica BORA 5000 12 페이지. Dry vacuum cleaner with water filter
Arnica BORA 5000에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지), 운영 매뉴얼 (12 페이지)
페이지 인쇄
the mains plug from the wall socket.
• Always empty, clean and dry container after wet use. Let
the appliance suck in dry air for few minutes to dry the
inside of the tubes and hose. This prevents unpleasent
smell and prevents the paper dust bag from becoming
wet.
• Do not point the hose at the eyes or ears nor put it in
your mouth when the appliance is switched on.
• Take particular care when cleaning stairs.
• Switch off immediately in the event of leaking liquid.
• Use only original accessories and spare parts to ensure
the perfect performance of your cleaner and to benefit
from the guarantee.
• For repairs or spare parts, contact your local service
agents.
WARNING : Never use the appliance to clean up flammable
or explosive solvents, object soaked with such solvents,
explosive dusts, liquids such as petrol, oil, alcohol, thinners
and objects that are hotter than 60 oC, as this will cause
a serious explosion and fire hazard! The appliance must
not be used near flammable substances and must not be
used to clean up health endangering dust.
Warning: Only perform dry vacuuming with your
vacuum cleaner.
II. GENERAL DESCRIPTION
Main parts of the appliance are shown as follows (Figure 1)
A. MOTOR UNIT
This group contains motor, switch and operating units on.
Top of this group, there is a HEPA FILTER which filters dust
and other particles from blowing air.
A1. ON-OFF switch
A2. Cord rewinder button
A3. Hepa Filter
A4. Hepa Filter housing cover
A5. Suction inlet
A6. Body handle
A7. Wheels
A8. Clamp housing
A9. Motor Protective S Filter
B. CONTAINER GROUP
Container Group is for collecting dust and dirty water.
This group is placed on the Body group.
B1. Transparent Water tank
B2. Cover of the Transparent Water tank
B3. Handle of the Transparent Water tank
B4. Water Filter Body
B5. Water filter tube loophole
C.THE HOSE GROUP
This group contains suction hose with hand grip and
suction tubes. Suction nose is connected to container
group by inserting the suction hose into the suction inlet.
Suction tubes are connected to hand grip if necessary.
Handgrip contains a manual sliding for regulating suction
power. Hose group can be placed onto the motor unit by
the help of hanger.
C1. The flexible suction hose
C2. Telescopic pipe
C3. Main brush
C4.Turbo brush
D. ACCESSORIES GROUP
There are various accessories for different cleaning
purposes.
D1 - Accessories Holder
D2 - Crevice Nozzle
D3 - Round Nozzle
D4 - Small Nozzle
D5 - Parfume
D6 - Mini Turbo Brush
D7 - Parquet Brush
III. TECHNICAL SPECIFICATIONS
Model
Voltage
Power
Electrical Insulation class : II
Cord Length
IV. PREPARING FOR USE
• ATTENTION – Do not insert the mains plug into the
wall socket until the appliance is completely ready for
use.
• Lift the Reservoir Group and put aside by holding from
its handle.
• Remove the water filter tube and Water Filter Body by
pulling after you open the reservoir cover.
• Check the parts and accessories in the Operating
Manual with the ones you take out of the Tank. Check
whether they are missing or damaged.
• If you will use your vacuum cleaner immediately, add
water in the Transparent Water Tank in accordance
with the maximum level (Maximum 1.2 liter) indicated
10
: BORA 5000
: 220-240V~ 50-60Hz
: 2400W Max.
: 6m.