Discount Equipment MGT MPC 80 기술 매뉴얼 - 페이지 5

{카테고리_이름} Discount Equipment MGT MPC 80에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Equipment MGT MPC 80 8 페이지.

Working Operation

1) START

• Turn the power switch – ON position (1).

• Move fuel lever to the right (2).

• Move choke lever left (3).

• Move throttle to minimum speed position (4).

• Slowly pull the rope start (5), until you feel resistance. Allow the handle

to pull back to the starting position and pull hard.

• Allow the engine to warm up for a few minutes and move the choke to

the right and the throttle to full speed to begin compacting.

2) TURN OFF THE ENGINE

• Move throttle lever to minimum speed.

• Move fuel tap right to close.

• Turning the power switch to OFF position.

3) HOW TO OPERATE PROPERLY

• Start the drive motor.

• Move throttle to full speed position.

• Guide the vibratory compactor by its handle. Let the machine move, do

not try to force the machine.

• Stop the operation: reduce to minimum acceleration, for the engine

operate to idling speed, close the fuel valve, let the engine shut down and

move the power switch to the OFF position.

1) ENGINE OIL LEVEL:

• Remove oil level indicator and measure.

• Oil level should be between minimum and maximum marks.

2) REPLACE ENGINE OIL:

• Place a drainer recipient at the end of the machine's oil drain.

• Remove oil ﬁll cap, oil indicator.

• Remove the engine drain plug.

• Drain oil while engine is warm to ensure quick and complete drainage.

• When the engine is completely empty disconnect the oil ﬂow pipe and

replace oil.

3) AIR FILTER

• Loosen the air ﬁlter cover.

• Remove air ﬁlter and clean to engine manufacturer's speciﬁcations.

• In case of damage or excess impurities, replace the ﬁlter element.