Cub Cadet RT-75 운영자 매뉴얼 - 페이지 9
{카테고리_이름} Cub Cadet RT-75에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cub Cadet RT-75 20 페이지. Rear tine
페이지 인쇄
4.
Secure the throttle cable to the handle with a cable tie as
shown in Figure 3-5.
Figure 3-5
Handle Pivot Control Rod
1.
Secure the handle pivot rod control onto the swing handle
link using the two thrust washers and cotter pins as shown
in Figure 3-6.
Figure 3-6
2.
Once in place, secure the handle by bending the cotter pins
outward.
Set-Up
Tires
The tires on the tiller may be over-inflated for shipping purposes.
Reduce the tire pressure before operating the tiller. Recommended
operating tire pressure is approximately 20 PSI (check the sidewall
of the tire for the manufacturer's recommended pressure). Be sure
that both tires are inflated equally or the tiller will pull to one side.
Gas & Oil Fill-Up
Service the engine with gasoline and oil as instructed in the
separate Engine Operator's Manual packed with your tiller. Read
the instructions carefully.
WARNING!
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Adjustments
Handle
The handle should be adjusted so that when the tiller is digging
3-4" into the soil, the handle falls to about waste-high. Rotate
the handle adjustment lock rearward, move the handle to the
desired position and then lock into place by rotating the handle
adjustment lock forward to secure the handle. See Figure 3-7.
Figure 3-7
S
ection
3 — A
& S
-U
SSembly
et
p
9