DiscountRamps TBSR-92 지침서 - 페이지 3

{카테고리_이름} DiscountRamps TBSR-92에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. DiscountRamps TBSR-92 4 페이지.

STEP 1. Place the left and right longitudinal beams (1, 2) on the right side of the pickup bucket, as shown

in figure I, to see if drilling is needed, if you need to drill,confirm the drilling position first, remove the

left and right longitudinal beam (1, 2) .Drill the diameter of 13 hole with the hand electric drill,then

assemble right longitudinal beam(1),With the outer hexagonal bolt full thread (4)into the 12 Spring

washer (5), 12 large flat washer (6), the right longitudinal beam (1) on the U-type mounting plate (3) in

turn, all bolts tightened and fixed. The left longitudinal beam (1) is installed the same as the right one

as shown in Fig.1.

Fig.1