DISCOVER 12-36-6700 운영 매뉴얼 - 페이지 5

{카테고리_이름} DISCOVER 12-36-6700에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DISCOVER 12-36-6700 13 페이지. For motive power applications
DISCOVER 12-36-6700에 대해서도 마찬가지입니다: 설치 매뉴얼 (6 페이지), 운영 매뉴얼 (14 페이지)

DISCOVER 12-36-6700 운영 매뉴얼
3. Design Features & Components

3.1 Battery Management System (BMS)

BMS Monitors
Cell module voltage
Battery voltage
Battery current
Battery temperature
Battery state of charge (SOC)
Module Balancing
BMS performs balancing of cell modules
Protection & Fault Management
BMS sounds buzzer when fault limits are reached
BMS generates fault when maximum operating limits are reached
Fault events cause switch to open and battery to shut down after a 120s delay
Communication Ports
BMS has an isolated USB and CAN communication.
Discover Accessory CAN Bus Battery Discharge Indicator p/n 950-0005 may be used to display battery SoC.
Discover Accessory CAN Bus Battery Discharge Indicator (Fully Featured) p/n 950-0005 may be used to display battery
SoC, Voltage, Current, Charge and Discharge Amp Hours and Equipment Run Hours.
Discover Accessory Harness p/n 790-0018 may be used to connect the battery to a computer running AES Dashboard
Software.
Data Logging
Monitoring data
Fault and warning events
Logged data is accessed using AES Dashboard software via the USB port (Win32, Win64 supported)

3.2 Fuse

Fuse provides back-up over-current protection.
A blown fuse requires replacement by a qualified installer - contact your Discover supplier.

3.3 Terminals

Terminals are button-type, M8 female.

4. Handling

• Battery should be set to OFF
• Battery cables should be disconnected
• Battery terminals should be protected
• Battery handle should be used to lift battery
• Battery should be handled by two people or mechanical lift equipment
• Do not lift or carry the battery during usage or operation

5. Installation

▲ WARNING!
Read Safety Section before installing the battery.
▲ WARNING!
Read Safety Section before installing the battery.
▲ CAUTION!
Do not install AES LiFePO
appropriate AES battery model for the voltage of your system.
batteries in series. Select the
4
5