DISCOVER 15-24-1000 운영 매뉴얼 - 페이지 4
{카테고리_이름} DISCOVER 15-24-1000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DISCOVER 15-24-1000 11 페이지. Lithium ion battery
페이지 인쇄3. Design Features & Components
3.1 Battery Management System (BMS)
Monitoring
BMS monitors:
•
Cell module voltage
•
Battery voltage
•
Battery current
•
Battery temperature
•
Battery state of charge (SOC)
Module Balancing
•
BMS performs balancing of cell modules.
Protection & Fault Management
•
BMS sounds buzzer when fault limits are reached
•
BMS generates fault when maximum operating limits are reached
•
Fault events cause switch to open and battery to shut down after a 120s delay
Communication Ports
BMS has an isolated RS232 communication port (for service technician use only).
3.2 Fuse
Fuse provides back-up over-current protection.
Fuse Replacement
A blown fuse requires service from a qualified technician. Contact your Discover supplier for more information.
3.3 Terminals
Terminals are post-type, M6 female.
4. Handling
• Battery should be off
• Battery cables should be disconnected
• Battery terminals should be protected
• Battery handle should be used to lift battery
• Do not lift or carry the battery during usage or operation
5. Installation - Single Battery
▲ CAUTION!
Do not install batteries in series. Select the appropriate
AES battery model for the voltage of your system.
▲ NOTE!
Intentional bypassing of BMS to operate battery outside
maximum and minimum limits voids warranty.
Terminal Torque
▲ WARNING!
Read Safety Section before installing the battery.
▲ WARNING!
Read Safety Section before installing the battery.
7.0-7.7 Nm / 5.1-5.7 Ft-lb
4