DISCOVER 15-36-1000 운영 매뉴얼 - 페이지 5

{카테고리_이름} DISCOVER 15-36-1000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DISCOVER 15-36-1000 11 페이지. Lithium ion battery

페이지 인쇄

1. Installation

5.1 Tools

• Insulated tools sized to match nuts, bolts and cables in use

• Voltmeter

• Post cleaner and wire brush

• Personal protective equipment

5.2 Securing Battery

• Battery can be strapped in place with non-conductive nylon straps

5.3 Installation

• Check that battery is switched off

• If battery circuit has disconnect, open disconnect to isolate battery

• Clean cable connections. Broken, frayed, brittle, kinked or cut

cables should be replaced

• Install and secure new battery. Be careful not to ground the

terminals to any metal mounting, fixture, or body part

• Connect battery cables. Connect ground cable last to avoid sparks

• Recommended terminal torque is 7 .0 – 7 .7 Nm (5.1 – 5.7 ft-lb)

• Close circuit disconnect (if open)

• Turn battery switch on

Terminal burnout is caused by:

• Discharge currents exceeding allowable limits

• Improper cable installation

• Improper cable sizing

• Improper terminal torque

6. Operation

6.1 On–Off

• To turn the battery on press and hold switch for 2-3 seconds

• To turn the battery off press and hold switch for 2-3 seconds

6.2 Charging

Before operating the charger make sure to read and understand the instructions that come with the charger. Never attempt to

charge a battery without first reviewing and understanding the instructions for the charger being used.

1. Connect the charger leads to the battery.

2. Make sure that the charger lead, both at the charger and the battery side, connections are tight.

3. Turn the charger on.

4. Turn the battery on (if required).

▲ NOTE!

All cables ends must be connected to battery terminals

without any washers between terminal bushings and

cable ends.

▲ NOTE!

Without exception, product experiencing terminal burn

out will not be warranted.

▲ NOTE!

Review operating limits.

▲ CAUTION!

Always make sure the chargers charging curve meets the

battery's charging requirement; never charge a visibly

damaged battery; never charge a frozen battery.

Copper compression lug

Shrink-wrap to

color-code the cable

Terminal surface

M6" bolt (supplied)

Lock washer (supplied)

Flat washer (supplied)

Battery cable lug

Ensure nothing is between

the terminal surface and the

battery cable lug