3D Creator HT3D-110 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} 3D Creator HT3D-110에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Creator HT3D-110 7 페이지.

페이지 인쇄

Supporting 3D Video Formats (Input):

Signal

720p

1080p

Technical Specification

HDMI Input

HDMI Output

HDMI Standard (RX)

(TX)

Operation pixel

frequency range

Single Link Range

HDMI DDC Signal

Input Video Signal

Remote Control

Power Supply

Support Output

3D Formats

1. When there is no picture presented, please:

 Make sure the direct connection from the source device to the display device without the 3D

Creator is working.

 Check if all connectors are connected well; and check if all cables can support the transmission

speed. High Speed HDMI cables are recommended.

 Check the power of 3D Creator in on.

 3D Creator does not have de-interlace function, please set the output signal of source devices

to 1080p, 720p, or 480p.

 3D Creator may not support some 3D videos that are formatted in 1080p/24fps. It may cause no

pictures presented on the sink device.

2. When there is only picture displayed and without sound:

 Check the cable connection to see if it fits properly.

 Check your cable to see if it supports video transmission only (DVI) or it is damaged.

 HDCP may not match very well at first connection; please restart your 3D Creator.

Resolution

Frequency

60Hz

1280 x 720

50Hz

60Hz

1920 x 1080

50Hz

HDMI Receiver (Type A 19-pin female) x1 / Gold plated

HDMI Transmitter (Type A 19-pin female) x1 / Gold plated

Compliant with HDMI 1.3a , HDCP 1.2

Compliant with HDMI 1.3a , HDMI 1.4a 3D , HDCP 1.2

link clock rate of 225MHz

2.25Gbps

5Vp-p

1.2 Vp-p max.

Frequency carrier of 38kHz

DC 5V/1A

Active Shutter 3D Display based on same conditions

1. Frame Packing - Frame sequential 60Hz ( DLP-Link)

2. Side-by-Side (Half)

3. Chequer Board Encoding ( Left-Blue / Right-Red )

TROUBLE SHOOTING

3D video format

Side-by-Side (Half)