Cubby Bed 사용자 설명서 - 페이지 7
{카테고리_이름} Cubby Bed에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cubby Bed 17 페이지.
페이지 인쇄
3
Assemble the #22 slats by following their included instructions. Do not peel off
the white tape. Mount the slats onto the frame. The tabs attached to the #9 and #10
connectors should be on the inside corners and the slats should rest fully on the
length tubes. Secure the slats to the frame with the #16 Velcro straps.
9
22
Insert #1 pole into both #8 connectors. Repeat for the other set. Lightly tighten
4
screws with #19 hex key. Slide #1 + #8 assembly onto the #2 vertical corner poles.
Line up the connectors on both sides at the same time. This may require two people.
Be careful not to pinch your fingers. Fully tighten screws with the #19 hex key.
1
Push Poles all the
way into connectors
10
2
8
16
9
Bed slats fit
around metal tab on
corner connectors
Gap between
slats and short ends of
bed is normal
8
1
7