3D Factories EASY 3D MAKER 사용자 설명서 - 페이지 10

{카테고리_이름} 3D Factories EASY 3D MAKER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Factories EASY 3D MAKER 14 페이지.

UPOROZNĚNÍ !

Do not use other then recomendet materials. The printer can be damage.

9.2 ZAVEDENÍ STRUNY A VÝMĚNA STRUNY (BARVY, MATERIÁLU)

Ze zásobníku ve spodní části stroje je vyvedeno vedení struny (bílá trubička) do tiskové hlavy extrudéru. Konec

struny upravte dle obrázku a nasuňte do vedení.

Leadership strings (white tube) out of the extruder and pull the string about 10 cm so that sticking out of the

tube. Push the end of the line between the pressure and the drive wheel (see picture below). The program

G3DMAKER start extruder and set the interval to run the extruder 30 mm and adjust the feed rate of 100 mm /

min. Temperature of extruder depend on material ABS 230°C and PLA 190°C preheat it before. Make sure the

string properly introduced into the hole under the drive wheel. After loading strings insert lines (white tube)

back into the extruder.

VERSION: 1.9.2012

- 10 -