3D Factories EASY 3D MAKER 사용자 설명서 - 페이지 6
{카테고리_이름} 3D Factories EASY 3D MAKER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Factories EASY 3D MAKER 14 페이지.
페이지 인쇄8. PŘÍPRAVA PŘED TISKEM
Before print is necessary do this few steps. Please pay attention to this.
•
Doublecheck if the print bed is clean
•
Remove all debris and rests of material
•
Doublecheck if the print bed is put in the right way and strongly attached
•
Doublecheck it the nozzle is clean
•
Doublecheck and correct height of nozzle over print bed
•
Doublecheck if the filament is correctly put into extruder and spool is correctly put in printer
8.1 TISKOVÁ PLOCHA
Before first launch of the printer check if the print bed is clear and without rest of material. Each printer is
tested before packing and can happen that there will be some rests of material. By the same way check it
before each next print.
8.2 ODSTRANĚNÍ NEČISTOT
If on the print bed are some debris, remove it with spatula or knife.
VERSION: 1.9.2012
© AROJA, s.r.o. 2012
- 6 -