3D Hobby Shop 57" Extra 330 SC 조립 설명서 - 페이지 11

{카테고리_이름} 3D Hobby Shop 57" Extra 330 SC에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop 57" Extra 330 SC 16 페이지.

Mount the rudder servo and assemble the connectors onto the rudder servo arm as shown. Note that the

connectors must be free to rotate on the servo arm. We use CA to lock the nut on the bottom of the

connector for this reason.

Assemble the front ends of the pull-pull cables as shown, double looping the wire through the crimp

sleeve. NOTE: the pull-pull cables cross over once inside the fuselage, forming an "X". Adjust your pull-

pull cables to be snug, with no sag, but not too tight. "Banjo-string-tight" pull-pull cables only sap the

power from your rudder servo and cause poor handling. Just snug is all you need.

Use the X-mount for your motor to mark the firewall for drilling. Drill the 4 mounting holes.