3D Hobby Shop Edge 540 조립 설명서 - 페이지 8
{카테고리_이름} 3D Hobby Shop Edge 540에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Edge 540 17 페이지.
페이지 인쇄8
Use a piece of tape to immobilize the rudder, and make sure the rudder servo is centered.
Assemble the cables onto the pull wire ends, crimp, and add a drop of thin CA to the crimp joints. The
cables cross once inside the fuselage to form an X shape. It is perfectly fine for the cables to lightly rub
against each other. Use the adjustors to set the cable tension. We only want the cables tight enough not
to sag. Any tighter and this will cause drag on the servo and rob servo power.